Guitar & bass EQ chart
Where mud, honk, bite and fizz live - and which knob on your amp moves each one.
The chart is free. Song settings for your exact gear are what ToneMirror does.
Tap a band to see what it does and which knob moves it.
Solid: fundamentals. Faded: harmonics and attack. Open low E (82 Hz) to the 24th fret on the high E (about 1.3 kHz); harmonics and pick attack run higher. Drop C reaches 65 Hz, a seven-string's low B 62 Hz.
Body and mud
200-500 HzWarmth and body - the weight of a chord. It is also where mud builds up, especially with a lot of gain.
- Too much
- Muddy, boxy, cardboard-sounding chords where the notes blur together.
- Too little
- Thin and brittle; high gain turns fizzy without the body underneath.
- What to do
- Cut a little here - or lower bass and gain - before reaching for more treble.
On your amp: Bass and the lower end of the middle control
An electric guitar lives between about 80 Hz and 5 kHz. Rumble sits below 80 Hz, thump at 80-200 Hz, body and mud at 200-500 Hz, honk at 500 Hz-1 kHz, bite and pick attack at 1-3 kHz, and edge and fizz at 3-6 kHz. Bass guitar sits lower: weight at 40-100 Hz, punch at 100-250 Hz, growl at 500 Hz-1 kHz and clank at 1-3 kHz.
- Muddy? Cut a little around 200-500 Hz before adding treble.
- Buried in the band? Raise the mids, not the volume.
- Fizzy distortion? Presence down first, then a little gain.
- In a band, high-pass the guitar around 80-100 Hz and leave the lows to the bass.
Which knob is that?
An amp's tone controls are not a graphic EQ. Each one covers a broad region, they interact with each other (the tone stack), and where each control is centred varies from one amp design to the next - so treat these ranges as rough maps, not specifications.
- Resonance / depthRoughly below 150 Hz
A low-end boost in the power amp, around the speaker's resonance - thump under palm mutes. Common on high-gain amps and modelers, and easy to overdo at low volume. Resonance →
- BassRoughly 60-250 Hz
Low end and thump. On many amps it also changes how much the middle control does, because the controls interact. Tone stack →
- MiddleRoughly 400 Hz-1 kHz centre
Body, honk and how far forward the guitar sits. Where the centre falls varies a lot from one amp design to another. Mids →
- TrebleRoughly 2 kHz and up
Bite and attack. With gain, it is also how much edge reaches the speaker. Gain →
- PresenceRoughly 3-6 kHz
Upper treble in the power amp - air and edge above the treble control. The first knob to turn down when a distorted tone fizzes. Presence →
- Bright switchUpper treble, mostly at low volume settings
Adds treble that is most noticeable with the volume low; often switched off as the amp gets louder. Bright switch →
What each knob does in practice, and how far to turn it, is in guitar amp settings explained.
Common EQ problems and how to fix them
Name the problem, find its band, then cut before you boost.
Muddy
200-500 HzCut a little in the low mids, lower bass, and try less gain - mud and gain build together. A mid-boosting overdrive in front of a high-gain amp tightens the lows going in.
Boomy
80-200 HzLower bass and resonance. A cabinet on the floor or in a corner adds bass on its own, so check it where you play.
Harsh or ice-pick
2-4 kHzEase treble and presence, roll the guitar's tone knob back a little, or move toward the neck pickup.
Fizzy distortion
3-8 kHzPresence down first, then a little less gain. On a modeler or IR loader, a high cut around 6-8 kHz.
Thin
100-300 HzRaise bass and mids, use the neck or middle pickup, and check the gain - very high gain can thin a tone out.
Buried in the band
500 Hz-2 kHzRaise the mids rather than the volume. More level just makes the whole band louder; more mids gives the guitar its own space.
Scooped metal that vanishes live
500 Hz-1 kHzBring the mid knob back toward the middle and cut lows instead - the guitar stays heavy and finally cuts through the drums.
Scooped mids are covered in the glossary and the metal tone guide; clean tones that won't stay clean are in the clean tone guide.
EQ for the band, not the bedroom
- Leave the lows to the bass. In a band, high-pass the guitar around 80-100 Hz or simply run less bass than sounds right alone.
- Cut before you boost. Taking a little out of a crowded band usually helps more than adding to another one, and keeps the amp out of mush.
- Mids are your place in the mix. Two guitars sound bigger when they differ - different pickups, or one a little brighter - than when both are scooped.
- EQ at the volume you play. The ear hears less bass and treble when it is quiet (the equal-loudness effect), so a bedroom EQ turns boomy and harsh on stage. More in getting good tone at low volume.
- Small moves. A notch on a knob or a couple of dB on a pedal is usually enough; big moves trade one problem for another.
Where real records put the knobs
A chart gives you the map; recordings give you the destination. These are the median settings documented for recorded hard rock and heavy metal guitar tones - and for any genre in the amp settings finder.
Guitar frequency chart
| Band | Range | What it does | Amp control |
|---|---|---|---|
| Rumble | 20-80 Hz | Below the open low E (about 82 Hz), so a standard-tuned guitar plays almost nothing here - it is cabinet thump, handling noise and room boom. | Resonance or depth, where the amp has one |
| Low end and thump | 80-200 Hz | The fundamentals of the lowest strings and the chest-thump of palm mutes. | Bass |
| Body and mud | 200-500 Hz | Warmth and body - the weight of a chord. It is also where mud builds up, especially with a lot of gain. | Bass and the lower end of the middle control |
| Mids and honk | 500 Hz-1 kHz | The core midrange that makes a guitar sound like a guitar and gives it a place in the band. | Middle |
| Bite and attack | 1-3 kHz | Pick attack, note definition and cut - the upper mids, where the ear is most sensitive. | Treble, and the top of the middle control |
| Edge and fizz | 3-6 kHz | Brightness and edge. On a distorted tone it is also where fizz lives. | Presence and treble |
| Air | 6-20 kHz | Most guitar speakers roll off steeply above about 5-6 kHz, so a miked electric has little real content here - mostly hiss and noise. | Presence, bright switch |
Bass frequency chart
| Band | Range | What it does | Amp control |
|---|---|---|---|
| Sub | 20-40 Hz | Felt more than heard. The open E of a four-string is about 41 Hz; a five-string's low B is about 31 Hz and does reach down here. | Bass, or a sub/low shelf on a preamp |
| Weight | 40-100 Hz | The fundamentals of the lowest notes, shared with the kick drum. | Bass |
| Punch and warmth | 100-250 Hz | The punch that makes a bass line move and feel round. | Bass, low mids |
| Mud and boxiness | 250-500 Hz | Body that turns into mud when it piles up with guitars and keys. | Low mids |
| Growl and definition | 500 Hz-1 kHz | Note definition and growl - the range that lets a bass line be heard on small speakers and phones. | Middle |
| Attack and clank | 1-3 kHz | Finger and pick attack, and the clank of a bright, metal-style bass. | High mids, treble |
| String zing and slap | 3-8 kHz | String brightness, fret noise and the pop of slap. | Treble |
| Air and hiss | 8-20 kHz | Little bass content - mostly hiss from active electronics and DI noise. | Treble |
Bass players: the full picture, from DI and amp blend to strings, is in the bass tone settings guide.
Guitar EQ - FAQ
What is the frequency range of an electric guitar?
A standard-tuned guitar's notes run from about 82 Hz (the open low E) to roughly 1.2-1.3 kHz at the top of the neck. Harmonics and pick attack reach well above that, but most guitar speakers roll off steeply above about 5-6 kHz, so a miked electric guitar's useful range is roughly 80 Hz to 5 kHz.
What frequency is mud on a guitar?
Mostly between about 200 and 500 Hz. Too much there makes chords boxy and indistinct, especially with a lot of gain. Cut a little in that range - or lower the bass and the gain - before reaching for more treble.
What frequency makes a guitar cut through the mix?
The upper mids, roughly 1 to 3 kHz, where pick attack lives and the ear is most sensitive - helped by the core mids around 500 Hz-1 kHz. Raising the mids usually makes a guitar cut more than raising its volume.
Where is the fizz in a distorted guitar tone?
Roughly 3 to 6 kHz and above. Turn the presence down first, then try a little less gain. On a modeler or IR loader, a high cut somewhere around 6-8 kHz removes it.
What frequencies does a bass guitar cover?
A four-string bass's open E is about 41 Hz and a five-string's low B about 31 Hz; most bass notes sit below about 400 Hz. Weight lives at 40-100 Hz, punch at 100-250 Hz, growl at 500 Hz-1 kHz and attack or clank at 1-3 kHz.
Should I high-pass my guitar?
In a band mix, usually yes: a high-pass around 80-100 Hz removes rumble the guitar doesn't need and leaves the low end to the bass and kick drum. Playing alone, or as a guitar-and-drums duo, keep more of the lows.
Which amp knob controls which frequency?
Roughly: bass below about 250 Hz, the middle control somewhere around 400 Hz-1 kHz, treble from about 2 kHz up, and presence the upper treble around 3-6 kHz. The exact centres vary from one amp design to another, which is why the same knob numbers sound different on two amps.
Go deeper
- GainBassMidTrebleSettings explained10 min read
Guitar Amp Settings Explained: Gain, Bass, Mid, Treble and Presence
What each amp knob really does, how they interact, and the median settings behind thousands of recorded guitar tones - so you can dial in faster.
Read the guide - Start here8 min read
Why Your Guitar Doesn't Sound Like the Record (and How to Fix It)
You copied the settings and it still sounds wrong. The six real reasons a recorded guitar tone doesn't transfer to your rig - and what to change first.
Read the guide - GainBassMidTrebleSettings explained7 min read
How to Get a Good Guitar Tone at Low Volume (Bedroom Tone)
Why your amp sounds thin and fizzy at bedroom volume, and how to fix it: EQ for low volume, master-volume and attenuators, less gain, headphones and modelers.
Read the guide - GainBassMidTrebleBass9 min read
Bass Guitar Tone Settings: EQ, Pickups and Amp Setup for Any Song
How to dial in a bass tone that sits like the record: amp EQ, P vs J pickups, fingers vs pick, compression and drive, from real recorded settings.
Read the guide















